top of page
Honda CB1300 'Thug' Yokes to fit USD front end

Honda CB1300 'Thug' Yokes to fit USD front end

Billet Thug replacement yokes for the mighty Honda CB1300 (non fairing type). These bad boys are an enormous 70mm thick, and designed to fit the USD forks, wheel, brakes etc from a late Fireblade, Hayabusa, TL1000 or pre-2000 GSXR, allowing you to slide the legs down up to 50mm (2"). which may eliminate the need for extensions (typically, USD legs 'sag' less than RWU legs, particularly with the preload wound up, which means you can often allow another 20mm. Please check to see if this is enough!). They will transform the front end of your beloved bike, while allowing the refitting of the original clocks, ignition, light mounting frame etc. They include steering stops, and the ignition and immobiliser mounts are at the same angle as the original (see last pic). The top and bottom yokes have 5 pairs of stainless clamp bolts! Count them...1..2..3..4.....5! They are chunky and very very strong, and offer a complete 'plug & play' swap. When ordering, please specify which legs you wish to fit (Blade, GSXR Hayabusa etc), and if you are fitting the whole front end or just the forks. We also make these yokes for re-fitting the original CB1300 forks.
All our yokes are made to order in Rural England, and typically take 4-6 weeks to make, though it can be as little as 3 weeks, and as much as 9-10 weeks, depending on time of year. Please allow for this when ordering.
If you prefer, we can send you a PayPal invoice for a £100 deposit, and then another for the balance when finished.
thank you.

    bottom of page